Comments on: Alternatives for Jump Cups

By: Carol

Carol — Tue, 31 May 2011 20:15:48 +0000

We my husband built ours we just took a pvc cap and cut it in half. and used the two halves for the cups

By: Gregory Gunther

Gregory Gunther — Sun, 29 May 2011 13:27:52 +0000

I have a question about the Dura Snap parts. That seems like the best solution for jump cups. But the part is 3/4″. Will these snap onto (and stay on) the 1″ vertical uprights on my jumps?
Thanks.

By: Michelle

Michelle — Fri, 15 Apr 2011 15:41:04 +0000

Another idea. Pipe clips (the correct diameter for the pipe) with holes cut for bolts. Cut a short length of bamboo just long enough to cover the bolt with a nut on the end. Thread the bolt through the centre of the bamboo and affix the bolt. Slid the pipe clip onto the pipe and if required finish the bamboo off with tape the same colour as the jumps. These are nice and stable, fully adjustable but will come apart if excessive force is applies. Also makes the jump nice and easy to move.

By: roxy

roxy — Fri, 15 Apr 2011 01:01:25 +0000

i couldent find a saddle piece, in NY its aganst building code, so no one carried it. in stead i got a T connecter, cut it in half at the mold line so i had two simetricale parts, so now you have a small nub tube with a half cut open one hanging off the side, you then cut about 1\4 off the back off the complete tube making it open *cut directly opposite the half open nub* this will form a saddle and you can sap on of off and slides just the right amount. FYI BTW P.S the connecter should be the same diameter as your up right